Laser Not Firing

If your laser not cutting through material as expected or not firing at all, it is almost always caused by either not focusing the laser head properly, or not closing the cover completely. The cover to the laser must be closed to activate the safety switches. Additionally, you must have a chiller hooked up and working.

Focusing:

Your laser came with a dual red-dot laser focusing accessory. Place your material on the laser bed, use the arrow keys to move the laser head over the material and then press the Settings button. Now use the left or right arrow to raise or lower the work bed until the two red dots align on top of each other. Next press the left turn arrow button directly above the settings button and you are now focused.